Homogeneous lobe independent of the external temperature conditions, intensitive to air currents, sudden temperature variation and external interference such as rain, snow etc.
Adjustment of the size of the detection area is carried out by cutting segments off the masking lens. Electronic adjustments are performed by means of DIP-switches.
Technology : |
passive infrared and microprocessor |
|
---|---|---|
Optical characteristics: |
P.I.R. with 4 elements, 15 lenses with full independent masking possibilities |
|
Maximum Detection area (mounting height: 2.2m): |
2.5 m (W) x 1.5 m (D) |
|
Detection mode: |
motion |
|
Detection speed: |
0.1 to 1.5 m/s |
|
LED-signal: |
1 red LED:flashes for a few seconds after power-on |
|
Warm-up time: |
10 s |
|
Hold time: |
0.5 s ou 2 s |
|
Response time: |
< 200 ms |
|
Power supply: |
12 VDC - 10% à 24VDC +30% /12 to 24 V AC ±10% |
|
Frequency: |
50/60 Hz |
|
Power consumption: |
< 1 W |
|
Connection: |
terminal block |
|
Recommended cable section (terminal block): |
< 0.5 mm² |
|
Standard output: |
relay (free potential contact) |
|
Mounting height: |
3 m max |
|
Temperature range: |
from -30 °C to +55 °C |
|
Dimensions FLY: |
101 mm (W) x 41 mm (H) x 27 mm (D) |
|
Color (FLY-FCA-FSA): |
anthracite grey |
|
Length of cable: |
2.5 m |
|
Normconformity: |
This product conforms to all applicable European Union legislation. Please refer to the Declaration of Conformity for further information. |
Specifications are subject to changes without prior notice – Measured in specific conditions.
sensor only
FLY + FSA
FLY + FCA
Surface mount accessory for the FLY
Ceiling accessory for the FLY